LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2013 >> MKZ Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 60 (Engine System - General Information) >> General Procedures >> Cylinder Block Distortion >> Check

Cylinder Block Distortion: Check

WARNING: This page is about a different variant/trim than selected.
NOTE: Refer to the appropriate article for the specification.
  1. NOTE: Use a Straightedge that is calibrated by the manufacturer to be flat within 0.005 mm (0.0002 in) per running foot of length, such as Snap-On® GA438A or equivalent. For example, if the Straightedge is 61 cm (24 in) long, the machined edge must be flat within 0.010 mm (0.0004 in) from end to end.

    Use a Straightedge and a Feeler Gauge Set to inspect the cylinder block for flatness.

    General Equipment  : Feeler Gauge

G08062260
scientia non olet · About LEMON Manuals