Driver Air Bag Module: Installation
- With the locking buttons released, install the driver air bag module electrical connectors fully into the driver air bag module and seat the locking buttons.
- Align the driver air bag module locking pins to the steering wheel and, while pushing inward, seat the 2 driver air bag module locking pins to the steering wheel wire clips.
- Repower the SRS. For additional information, refer to SRS Depowering and Repowering .
NOTE:
The driver air bag module electrical connector locking buttons must be in the released position when connected. Do not install the driver air bag module electrical connectors by the locking buttons. Failure to follow these instructions may cause connector damage.