Removal And Installation
NOTE:
It is not necessary to remove the audio control module (ACM) to retrieve the part number. For additional information, refer to Audio Unit Part Number Retrieval .
- Upload the ACM configuration information to the scan tool. For additional information, refer to MODULE CONFIGURATION article to carry out programmable module installation (PMI).
- Remove the instrument panel center finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
- Remove the 4 screws and the ACM.
- Disconnect the electrical connectors, the antenna cable connector, and the global positioning system (GPS) antenna (if present).
- To install, reverse the removal procedure.
- Download the configuration information to the ACM. For additional information, refer to MODULE CONFIGURATION article to carry out PMI.
NOTE:
Module configuration is only required if a new ACM is being installed.