LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2012 >> IS 350C >> Repair and Diagnosis (Single Page) >> Brakes >> Traction Control >> Brake Control System (Service Information) >> Skid Control Buzzer >> Removal >> Removal

Skid Control Buzzer: Removal: Removal

  1. PRECAUTION 
    WARNING:

    Be sure to read Precaution thoroughly before servicing. Refer to PRECAUTION .

    NOTE:

    w/ Navigation System for HDD:

    After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  3. REMOVE DOOR SCUFF PLATE ASSEMBLY LH  . Refer to REMOVAL - Step 2
  4. REMOVE FRONT DOOR OPENING TRIM COVER LH  . Refer to REMOVAL - Step 3
  5. REMOVE INSTRUMENT SIDE PANEL LH  . Refer to REMOVAL - Step 30
  6. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  . Refer to REMOVAL - Step 31
  7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY  . Refer to REMOVAL - Step 32
  8. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY  . Refer to REMOVAL - Step 8
  9. REMOVE SKID CONTROL BUZZER ASSEMBLY 
    1. Remove the clamp and skid control buzzer assembly.
      Fig 1: Identifying Clamp And Skid Control Buzzer Assembly
      GTY267536Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the connector from the skid control buzzer assembly
scientia non olet · About LEMON Manuals