Rear Axle Hub Bolt: Replacement

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.

REMOVE REAR WHEEL
REMOVE REAR DISC BRAKE CALIPER ASSEMBLY LH (See REMOVAL )
REMOVE REAR DISC (See REMOVAL )
REMOVE REAR AXLE HUB BOLT LH
1. Using SST, remove the rear axle hub bolt.
  SST 09650-17011
  
  Fig 1: Removing Rear Axle Hub Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR AXLE HUB BOLT LH
1. Install a washer and nut to a new bolt as shown in the illustration.
2. Using a screwdriver or equivalent to hold the hub and bearing, install the rear axle hub bolt by tightening the nut
  NOTE: Do not damage the threads of the hub bolts.
  
  Fig 2: Removing/Installing Washer And Nut To Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR DISC (See INSTALLATION )
ADJUST PARKING BRAKE SHOE CLEARANCE (See PROBLEM SYMPTOMS TABLE )
INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH (See INSTALLATION )
INSTALL REAR WHEEL
Torque: 140 N*m (1428 kgf*cm, 103 ft.*lbf)