LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Supplemental Restraint System) >> Center Airbag Sensor Assembly >> Installation

Center Airbag Sensor Assembly: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY 
    1. Check that the engine switch is off
    2. Check that the cable is disconnected from the negative (-) battery terminal.
      CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
    3. Install the center airbag sensor assembly with the 2 bolts and nut

      Torque: 18 N*m (184 kgf*cm, 13 ft.*lbf) 

      Fig 1: Locating Bolts, Nut And Center Airbag Sensor Assembly
      G05757234Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:
      • If the center airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
      • When installing the center airbag sensor assembly, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
      • When the engine switch is first turned on (IG) after the center airbag sensor assembly has been replaced, make sure that no one is in the vehicle.
    4. Connect the holder (with connectors)
      NOTE: When connecting the airbag connector, take care not to damage the airbag wire harness.
    5. Check that the waterproof sheet is properly set.
    6. Check that there is no looseness in the installation parts of the center airbag sensor assembly
  2. INSTALL CONSOLE BOX  (See INSTALLATION )
  3. INSTALL CONSOLE BOX REGISTER ASSEMBLY  (See INSTALLATION )
  4. INSTALL REAR ASH RECEPTACLE ASSEMBLY  (See INSTALLATION )
  5. INSTALL FRONT ASH RECEPTACLE ASSEMBLY  (See INSTALLATION )
  6. INSTALL CONSOLE PANEL SUB-ASSEMBLY  (See INSTALLATION )
  7. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH  (See INSTALLATION )
  8. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH  (See INSTALLATION )
  9. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY  (See INSTALLATION )
  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  11. INSPECT SRS WARNING LIGHT 
    1. Inspect the SRS warning light (See DIAGNOSIS SYSTEM  )
scientia non olet · About LEMON Manuals