Inspection Procedure

1. Disconnect the multi-display connector and navigation ECU connector.
   Fig 1: Identifying Multi-Display Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value (s) in the table below.

   Standard resistance 

   STANDARD RESISTANCE SPECIFICATION
   
   

   Tester connection	Condition	Specified condition
   z23-5 (MIC-) - h1-4 (MIC-)	Always	Below 1 Ω
   z23-3 (MIC+) - h1-5 (MIC+)	Always	Below 1 Ω
   z23-5 (MIC-) - Body ground	Always	10 kΩ or higher
   z23-3 (MIC+) - Body ground	Always	10 kΩ or higher

Fig 2: Identifying Navigation ECU Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE