Seat Position Sensor: Installation

WARNING: This page is about a different car, the 2008 Toyota FJ Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

PRECAUTION
CAUTION: Read PRECAUTION thoroughly before servicing .
INSTALL SEAT POSITION SENSOR
1. Check that the ignition switch is turned to OFF.
2. Check that the negative (-) battery terminal is disconnected.
  CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.
3. Install the seat position sensor with the bolt.
  Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
  
  Fig 1: Identifying Seat Position Sensor Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Check that there is no looseness in the installation parts of the seat position sensor.
5. Connect the connector to the seat position sensor.
INSTALL FRONT SEAT ASSEMBLY LH (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
PERFORM INITIALIZATION
1. Perform INITIALIZATION .
  HINT:
  
  Some systems need initialization when disconnecting the cable from the negative battery terminal.
INSPECT SRS WARNING LIGHT
1. Inspect the SRS warning light (See DIAGNOSIS SYSTEM ).