Front Cooling Unit: Installation

INSTALL COOLING UNIT
1. Install the cooling unit with the 4 screws and 2 nuts.
2. Connect the connector.
  
  Fig 1: Identifying Cooling Unit Screws And Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL ANTENNA RELAY
1. Install the antenna relay with the 2 screws.
2. Connect the connector.
INSTALL INSTRUMENT PANEL REINFORCEMENT ASSEMBLY
INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
1. Install the instrument panel safety pad sub-assembly (see INSTALLATION ).
  
  Fig 2: Locating Antenna Relay Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT LIQUID TUBE AND SUCTION TUBE
1. Lubricate 4 new O-rings with compressor oil and install them to the tubes.
  Compressor oil:
  
  ND-OIL 8 or equivalent
2. Connect the liquid tube, suction tubes and piping clamp.
  HINT:
  
  After connection, check the claw engagement of the piping clamp.
  
  Fig 3: Connecting Liquid Tube And Suction Tube
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
CHECK SRS WARNING LIGHT
1. Check the SRS warning light (see DIAGNOSIS SYSTEM ).
CHARGE REFRIGERANT (See REPLACEMENT )
WARM UP ENGINE (See REPLACEMENT )
CHECK FOR LEAKAGE OF REFRIGERANT (See REPLACEMENT )