Air Conditioning Control Assembly: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

HINT:

At the time of installation, perform initialization (see INITIALIZATION ).

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
REMOVE CENTER CLUSTER FINISH PANEL
1. Disengage the 9 clips and remove the center cluster finish panel, and then disconnect the connector.
  
  Fig 1: Identifying Center Cluster Finish Panel Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CENTER RESISTOR
1. Disengage the 6 clips and remove the center resistors in both sides.
  
  Fig 2: Identifying Center Resistor Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE INTEGRATION CONTROL PANEL ASSEMBLY
1. Remove the 4 bolts.
2. Disengage the 7 clips and remove the integration control panel assembly, and then disconnect the connectors.
  
  Fig 3: Locating Integration Control Panel Assembly Blots
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE A/C AMPLIFIER ASSEMBLY (w/ Navigation System)
1. Disconnect the connector clamp.
2. Remove the 3 screws, 4 bolts and radio receiver bracket LH.
  
  Fig 4: Locating Radio Receiver Bracket LH Screws And Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the 2 screws and A/C amplifier.
  
  Fig 5: Locating A/C Amplifier Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE MULTI-DISPLAY (w/ Navigation System)
1. Remove the 2 screws, 2 bolts and the multi-display.
  
  Fig 6: Locating Multi-Display Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE INTEGRATION CONTROL PANEL (w/ Navigation System)
1. Disconnect the connector clamps.
2. Remove the screw, 2 bolts and radio receiver bracket RH.
3. Remove the integration control panel from the radio receiver.
  
  Fig 7: Locating Integration Control Panel Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE HEATER CONTROL PANEL ASSEMBLY (w/ o Navigation System)
1. Disconnect the connector clamp.
2. Remove the 6 bolts and radio receiver bracket LH.
  
  Fig 8: Locating Radio Receiver Bracket LH Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Disconnect the connector clamp.
4. Remove the 6 bolts and radio receiver bracket RH.
5. Remove the heater control panel.
  
  Fig 9: Locating Radio Receiver Bracket RH Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002