Height Control Sensor: Removal

HINT:

• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
   CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE HEIGHT CONTROL SENSOR SUB-ASSEMBLY FRONT 
   1. Remove the front tire.
   2. Disconnect the connector.
   3. Remove the nut and height control sensor link from the lower arm.
      Fig 1: Locating Height Control Sensor Link Nut

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   4. Remove the 2 bolts and sensor.
      Fig 2: Locating Height Control Sensor Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. REMOVE HEIGHT CONTROL SENSOR SUB-ASSEMBLY REAR 
   1. Remove the rear tire.
   2. Disconnect the connector.
   3. Put matchmarks on the sensor link and bracket.
      Fig 3: Putting Matchmarks On Sensor Link And Bracket

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   4. Remove the 2 bolts and sensor.
      Fig 4: Identifying Height Control Sensor With Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002