Headlight Protector Retainer Upper LH: Replacement

WARNING: This page is about a different car, the 2006 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE FRONT BUMPER ASSEMBLY (See REMOVAL )
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE RADIATOR SUPPORT SEAL UPPER (See REMOVAL )
REMOVE FRONT BUMPER FILLER (See REMOVAL )
REMOVE HEADLIGHT ASSEMBLY (See REMOVAL )
INSTALL HEADLIGHT PROTECTOR RETAINER UPPER LH
HINT:

When only the installation part of the headlight unit assy LH is damaged, it can be repaired inexpensively by using a headlight protector retainer upper LH. In this case, however, the headlight unit assy LH itself should not be damaged.
1. Cut off the part shaded in Fig 1 and sand smooth with sandpaper.
  NOTE: After cutting off the part, place the headlight protector retainer upper LH against the bosses and gradually file away the old bracket if it interferes with the installation of the supply bracket.
  
  Fig 1: Cutting Off Shaded Part & Smooth With Sandpaper
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the headlight protector retainer upper LH with the 2 screws.
  
  Fig 2: Installing Headlight Protector Retainer Upper LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
HEADLIGHT AIM ONLY (See ADJUSTMENT )