Section 31 (Charging): Generator: Installation

WARNING: This page is about a different car, the 2005 Lexus LX 470. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL GENERATOR
1. Install the generator with the bolt and 2 nuts.
  Torque:
  
  39 N.m (400 kgf.cm, 29 ft.lbf) for bolt
  
  39 N.m (400 kgf.cm, 29 ft.lbf) for nut A
  
  15.5 N.m (158 kgf.cm, 11 ft.lbf) for nut B
  
  Fig 1: Installing Generator
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the generator connector.
3. Connect the generator wire with the nut.
  Torque: 9.8 N.m (100 kgf.cm, 87 in.lbf)
4. Install the terminal cap.
5. Install the wire clamp to the cord clip on the generator.
INSTALL PS VANE PUMP (See INSTALLATION )
INSTALL RADIATOR ASSEMBLY (See INSTALLATION )
INSTALL GENERATOR DRIVE BELT
Install the belt.

HINT:

The pulley bolt for the belt tensioner has a left-hand thread.

Fig 2: Installing Generator Drive Belt
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
FILL RADIATOR WITH ENGINE COOLANT
START ENGINE AND CHECK FOR LEAKS
RECHECK ENGINE COOLANT LEVEL
PERFORM ON-VEHICLE INSPECTION (See ON-VEHICLE INSPECTION )
INSTALL ENGINE UNDER COVER NO. 1