Diagnostic Trouble Code Chart
WARNING: This page is about a different car, the 2008 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
If a trouble code is displayed during the DTC check (sensor check), check the circuit listed for the code in the table below .
AIR CONDITIONING SYSTEM:
AIR CONDITIONER SPECIFICATION
| DTC No. | Detection Item | Trouble Area | Memory *4 | See |
|---|---|---|---|---|
| B1411/11 *1 | Room Temperature Sensor Circuit |
|
Memorized (8.5 min. or more) | |
| B1412/12 *2 | Ambient Temperature Sensor Circuit |
|
Memorized (8.5 min. or more) | |
| B1413/13 | Evaporator Temperature Sensor Circuit |
|
Memorized (8.5 min. or more) | |
| B1421/21 *3 | Solar Sensor Circuit (Passenger Side) |
|
Memorized (8.5 min. or more) (only when circuit is shorted) | |
| B1422/22 *5 | Compressor Lock Sensor Circuit |
|
- | |
| B1423/23 | Pressure Switch Circuit |
|
- | |
| B1424/24 *3 | Solar Sensor Circuit (Driver Side) |
|
Memorized (8.5 min. or more) (only when circuit is shorted) | |
| B1431/31 | Air Mix Damper Position Sensor Circuit (Passenger Side) |
|
Memorized (1 min. or more) | |
| B1432/32 | Air Inlet Damper Position Sensor Circuit |
|
Memorized (1 min. or more) | |
| B1433/33 | Air Outlet Damper Position Sensor Circuit |
|
Memorized (1 min. or more) | |
| B1436/36 | Air Mix Damper Position Sensor Circuit (Driver Side) |
|
Memorized (1 min. or more) | |
| B1441/41 | Air Mix Damper Control Servo Motor Circuit (Passenger Side) |
|
Memorized (15 sec.) | |
| B1442/42 | Air Inlet Damper Control Servo Motor Circuit |
|
Memorized (15 sec.) | |
| B1443/43 | Air Outlet Damper Control Servo Motor Circuit |
|
Memorized (15 sec.) | |
| B1446/46 | Air Mix Damper Control Servo Motor Circuit (Driver Side) |
|
Memorized (15 sec.) | |
| B1451/51 | Compressor Solenoid Circuit |
|
Memorized (1 min. or more) | |
| B1499/99 | Multiplex Communication Circuit | Multiplex communication system | - | |
HINT:
|
||||
- With the engine running, enter the DTC check mode.
- Press the R/F switch to enter the actuator check mode, and set the operation to Step No. 3.
- Press the AUTO switch to return to the DTC check mode.
- The DTC is displayed after approx. 3 seconds.