Inspection Procedure
- Check RR SEAT LH and MPX-B1 fuse.
- CHECK:
Check continuity of RR SEAT LH and MPX-B1 fuse.
- OK:
Continuity
- NG:
Replace the failure fuse.
- OK:
Go to next step.
- Check voltage between terminals +B, SYSB and GND of rear LH seat ECU connector.
- PREPARATION:
- Turn the ignition switch OFF.
- Disconnect the rear LH seat ECU connector.
- CHECK:
Measure voltage between terminals +B, SYSB and GND.
- OK:
Voltage: 10-14 V
- OK:
Proceed to next circuit inspection shown on problem symptoms table (See PROBLEM SYMPTOMS TABLE ).
- NG:
Go to next step.
- Check harness and connector between rear LH seat ECU and body ground.
- OK:
Repair or replace harness or connector.
- NG:
Proceed to next circuit inspection shown on problem symptom table (See PROBLEM SYMPTOMS TABLE ).