LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2003 >> Range Rover >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel Delivery System >> Removal & Installation >> Pump - Fuel Tank >> Installation

Pump - Fuel Tank: Installation

  1. Clean area surrounding fuel tank access.
  2. Clean pump body and fit new tank seal to pump.
  3. Connect combined fuel pipe and multiplug from tank LH sender to pump assembly.
    CAUTION: Ensure clip is securely located after connection.
  4. Carefully fit pump and check seal is correctly seated. From LH aperture, check foot of pump to ensure correct alignment with tank.
  5. Using LRT-19-009, fit locking ring and tighten to 35 Nm (26 ft. lbs).
  6. Connect fuel pipes to pump.
  7. Remove container.
  8. Connect multiplug to fuel pump.
  9. Position fuel tank RH access panel, fit nuts and tighten to 10 Nm (7 ft. lbs).
  10. Connect battery earth lead.
  11. Refill fuel tank. See TANK - DRAIN .
  12. Connect TestBook/T4, to ensure new fuel level senders are working correctly, and reset adaptions.
scientia non olet · About LEMON Manuals