LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2019 >> Sorento L >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Heater System) >> Mode Control Actuator >> Repair Procedures >> Inspection

Repair Procedures: Inspection

WARNING: This page is about a different car, the 2020 Kia Sorento. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch OFF.
  2. Disconnect the mode control actuator connector.
  3. Verify that the mode control actuator operates to the defrost mode when 12V is connected to terminal 3 and ground to terminal 7.

    Verify that the mode control actuator operates to the vent mode when connected in reverse.

    G12885191Courtesy of KIA MOTORS AMERICA, INC.
    1. -
    2. -
    3. Defrost mode
    4. Sensor ground
    5. Feedback signal
    6. Sensor (+ 5V)
    7. Vent mode
  4. Connect the mode control actuator connector.
  5. Turn the ignition switch ON.
  6. Check the voltage between terminals 5 and 4.

    Specification 

    Door position Voltage (V) Error detecting
    Vent 0.45±0.15 Low voltage: 0.1V or less
    Defrost 4.55±0.15 High voltage: 4.9V or less

    It will feedback the current position of the actuator to controls.

  7. If the measured voltage is not within the specification, substitute with a verified temperature control actuator and check for proper operation.
  8. Replace the mode control actuator if it is proved that there is a problem with it.
scientia non olet · About LEMON Manuals