Repair Procedures: Disassembly

WARNING: This page is about a different car, the 2018 Kia Forte5 and 2018 Kia Forte. However, it is still accessible from the selected car via links, so may be relevant.

Remove the pully (A) after loosening the mounting bolt.

Fig 1: Removing Pulley Mounting Bolt
Courtesy of KIA MOTORS AMERICA, INC.
Remove the OAP cap (A).

Fig 2: Removing OAP Cap
Courtesy of KIA MOTORS AMERICA, INC.
Using the SST (09373-27000), remove the OAP pulley (A).

Fig 3: Removing OAP Pulley
Courtesy of KIA MOTORS AMERICA, INC.
Remove the rear cover (A) after removing nuts (B).

Fig 4: Removing Rear Cover Nuts
Courtesy of KIA MOTORS AMERICA, INC.
Remove the mounting bolts (A) and the regulator assembly (B).

Fig 5: Removing Mounting Bolts And Regulator Assembly
Courtesy of KIA MOTORS AMERICA, INC.
Remove the slip ring guide (A) after pulling it.

Fig 6: Removing Slip Ring Guide
Courtesy of KIA MOTORS AMERICA, INC.
Unsolder the 3 Stator Leads (A).

Fig 7: Unsolder Stator Leads
Courtesy of KIA MOTORS AMERICA, INC.
Remove the 4 through bolts (A).

Fig 8: Removing Through Bolts
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the rotor (A) and housing (B).

Fig 9: Disconnecting Rotor And Housing
Courtesy of KIA MOTORS AMERICA, INC.