Monitor Scantool Data

Connect scantool to Data Link Connector (DLC).
Ignition "ON" & Engine "ON".
Press the brake pedal.
Monitor the "Pressure Sensor" parameter on the Scantool.
Specification: Approx. 60bar ~ 150bar (There is difference in displayed parameter according to braking force)

Fig 1: Screen Display - Normal Data At Pressing Break Pedal
Courtesy of KIA MOTORS AMERICA, INC.
Whenever brake pedal is pushed down, is the pressure sensor's scantool data changed?
YES
- Fault is caused by having been repaired and HECU memory was not cleared. Clear the DTC and then go to VERIFICATION OF VEHICLE REPAIR procedure.
NO
- Go to COMPONENT INSPECTION procedure.