LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2010 >> Sedona Base >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Instrument Panel Module Diagnosis >> DTC B1628: Module Configuration Conflict >> Scantool Diagnostics >> Monitor Scantool Data

Monitor Scantool Data

  1. Connect scantool to Data Link Connector (DLC).
  2. Ignition "ON" & engine "OFF"
  3. Select "Diagnostic Trouble Codes (DTCs)" mode and monitor "DTC Status" parameter
  4. Is the DTC B1628 present?

    YES

    1. Go to "INSPECTION & REPAIR " procedure

    NO

    1. Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector or was repaired and ECM memory was not cleared.

      Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

scientia non olet · About LEMON Manuals