Section 162 (Front Half Shaft): Installation

WARNING: This page is about a different car, the 2018 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of CHRYSLER GROUP, LLC

Using axle seal protector (special tool #10270, Protector, Half Shaft, Drive) (1), install half shafts in the axle. Verify half shaft has engaged.
NOTE:
Use care when removing seal protector to prevent damaging the seal.

Courtesy of CHRYSLER GROUP, LLC
Install NEW coated washer on the outer C/V joint shaft.
Install half shafts (1) through the hub/bearing (2).
Install shock clevis on lower control arm and tighten nut to specifications.

Courtesy of CHRYSLER GROUP, LLC
Install upper control arm on knuckle and tighten ball joint nut to specifications.

Courtesy of CHRYSLER GROUP, LLC
Install tie rod end (1) on knuckle and tighten to specifications.
Install stabilizer link (7, 5) on lower control arm and tighten to specifications.
Install caliper on caliper adapter and tighten to specifications. Refer to CALIPER, DISC BRAKE, INSTALLATION .

Courtesy of CHRYSLER GROUP, LLC
Install wheel speed sensor (1) on the hub/bearing (3).
NOTE:
Always install a NEW hub nut. The original hub nut is one-time use only and should be discarded when removed.
Install a NEW half shaft hub/bearing nut and tighten to 310 N.m (229 ft. lbs.).
Install the wheel and tire assemblies.
Pump brake pedal until caliper pistons and brake pads are seated and a firm brake pedal is obtained.