Charging System (Service Information): Generator: Installation: 3.2L

Fig 1: Generator & Frame Rails

Courtesy of CHRYSLER GROUP, LLC

1. Carefully position the generator (1) up to the engine block.
   Fig 2: Generator & Mounting Bolts

   Courtesy of CHRYSLER GROUP, LLC
2. Loosely install the top two generator mounting retainers (2).
3. Install the lower generator mounting bolt (3).
   Fig 3: Removing/Installing A/C Compressor

   Courtesy of CHRYSLER GROUP, LLC
4. Position the A/C compressor (2) to the engine. Tighten the bolts to 28 N.m (21 ft. lbs.).
5. Lower the vehicle.
   Fig 4: Removing/Installing Right Engine Mount Assembly

   Courtesy of CHRYSLER GROUP, LLC
6. Install the upper engine mount bolts (2, 3). Tighten mount to mount bracket bolts (2, 3) to 72 N.m (53 ft. lbs.).
   Fig 5: Fuel Line At Fuel Rail

   Courtesy of CHRYSLER GROUP, LLC
7. Install the fuel line (2) at the fuel rail.
   Fig 6: Air Filter Housing Body

   Courtesy of CHRYSLER GROUP, LLC
8. Install the air filter housing body (1). Refer to BODY, AIR CLEANER, INSTALLATION .
   Fig 7: Generator Field Electrical Connector & B+ Retainer

   Courtesy of CHRYSLER GROUP, LLC
9. Raise the vehicle.
10. Tighten the generator mounting retainers to 25 N.m (18 ft. lbs.).
11. Install the generator B+ cable (3) on the generator stud.
12. Install the B+ cable nut (2), and tighten to 4 N.m (36 In. lbs.).
13. Connect the field generator harness Connector (1).
    Fig 8: Removing/Installing Belly Pans

    Courtesy of CHRYSLER GROUP, LLC
14. Install the belly pan (1).
15. Partially lower the vehicle.
    Fig 9: Removing/Installing Accessory Drive Belt

    Courtesy of CHRYSLER GROUP, LLC
16. Install the accessory drive belt. Refer to BELT, SERPENTINE, INSTALLATION .
17. Install the wheel.
18. Lower the vehicle.
19. Connect the battery negative cable.
20. Start the engine and verify the generator is operating properly.