Module, Ignition Node: Installation: Installation

Fig 1: Removing/Installing Switch Mounting Screws

Courtesy of CHRYSLER GROUP, LLC

1. Install the Ignition Node Module (IGNM) into the Instrument Panel from the backside.
2. Pull the Ignition Node Module into place.
3. Install 4 screws the IGNM and tighten.
4. Connect Electrical harness connector into IGNM.
5. Install the chin bezel. Refer to CONSOLE, FLOOR, INSTALLATION .
6. Install the steering column opening cover and connect the wire harness connectors.
7. Install dash end cap. Refer to CAP, INSTRUMENT PANEL END, INSTALLATION .
8. Connect negative battery cable.
9. If IGNM is being replaced, program the module. Refer to STANDARD PROCEDURE .