Front Seat
To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Chrysler Mopar® Parts Catalog.
- Position the front seat belt buckle (1) lower anchor to the bracket near the back of the upper inboard seat track.
- Reach under the seat cushion to access and reconnect the seat wire harness connector to the seat belt buckle switch pigtail wire (2) connector.
- Install and tighten the screw (3) that secures the buckle lower anchor to the bracket. Tighten the screw to 45 N.m (33 ft. lbs.).
- Reinstall the front seat into the vehicle. Refer to SEAT, INSTALLATION .
- Reconnect the negative cable to the battery.