Diagnostic Test

1) CHECK FOR OTHER DTC'S
With the scan tool, check the ECM for LIN Bus or System Voltage related DTC's.

Are there any LIN Bus or System Voltage related DTCs?

Yes
1. Repair other DTCs before continuing.
No
1. Go to step 2).
2) GENERATOR B+ CIRCUIT
Turn the ignition off.

Using a test light connected to ground, probe the B+ circuit at the generator.

Does the test tight illuminate brightly?

Continue
1. Go to step 3).
No
1. Repair the Generator B+ circuit for an open.
3) CHECK GENERATOR DRIVE BELT
Visually inspect the generator drive belt for glazing, cracks and other problems.

Inspect the generator drive belt and tensioner for proper tension.

Were any problems found?

Yes
1. Repair or replace as necessary.
No
1. Go to step 4).
4) TEST DRIVE THE VEHICLE
Turn the ignition on.

With the scan tool, erase DTC's.

Test drive the vehicle.

With the scan tool, read DTC's.

Does the scan tool display this DTC?

Yes
1. Replace the Generator.
No
1. Refer *CHECKING FOR AN INTERMITTENT CONDITION .