| Navigation soft key missing from Touch Screen (TS) menu |
- Car configuration file mismatch with vehicle specification
|
NOTE:
After updating the car configuration file, set the ignition to on and wait 30 seconds before clearing the DTCs.
- Using the Jaguar Land Rover Approved Diagnostic Equipment, check and up-date the car configuration file as necessary. Clear the DTCs and retest
|
| "Please insert map SD card to enter navigation" message after launching navigation |
|
- Insert map SD card into the navigation control module
|
| "Agree" message after launching navigation |
- Car configuration file mismatch with vehicle specification
|
NOTE:
After updating the car configuration file, set the ignition to on and wait 30 seconds before clearing the DTCs.
- Using the Jaguar Land Rover Approved Diagnostic Equipment, check and up-date the car configuration file as necessary. Clear the DTCs and retest
|
| Blank screen after launching navigation |
- Video in signal missing
- Navigation Control Module (NCM) not installed
- LVDS circuit short circuit to ground, short circuit to power, open circuit, high resistance
- Navigation Control Module (NCM) power or ground circuit open circuit, high resistance
- Medium speed CAN bus circuit short circuit to ground, short circuit to power, open circuit, high resistance
|
|
| Unable to detect position |
- GPS signal missing
- GPS receiver circuit short circuit to ground, short circuit to power, open circuit, high resistance
|
|
| No navigation audio |
- Telephone mute circuit short circuit to ground
- Navigation audio circuits short circuit to ground, short circuit to power, open circuit, high resistance
|
- Refer to the applicable SYSTEM WIRING DIAGRAM(S) and test the telephone mute circuit for short circuit to ground
- Refer to the applicable SYSTEM WIRING DIAGRAM(S) and test the audio circuits for short circuit to ground, short circuit to power, open circuit, high resistance
|