LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2000 >> XJ8 Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Servicing - A/T >> Adjustments >> Selector Cable >> 5R55N

Selector Cable: 5R55N

  1. Unclip parking brake boot, detach center console upper section, disconnect lighter connector and remove center console upper section. Disconnect transmission mode and traction control electrical connectors. Move selector lever to "R" position. Loosen selector cable lock nut and disconnect selector cable.
    2. NOTE: Transmission selector lever has its own detent mechanism. There is no need to hold it after engaging gear.
  2. Raise and support vehicle. Move rotary position switch at transmission to "R" position. Lower vehicle. Move selector lever to "R" position. Connect selector cable and DO NOT tighten selector lever lock nut. Move selector lever to "D" position.
  3. Hold selector lever applying light pressure and finger tighten rear lock nut, then finger tighten front lock nut. Move selector lever to different positions. When "D" position is selected, ensure it sits as close as possible to "D" position and "4" position in each corner.
  4. Tighten selector lever lock nut to specification. See TORQUE SPECIFICATIONS . Install center console upper section. Connect transmission mode and traction control electrical connectors. Connect lighter connector. Install center console upper section. Clip together parking brake boot.
scientia non olet · About LEMON Manuals