LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2001 >> Rodeo LS, 2.2 D >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Transfer Case) >> Transfer Case Assembly >> Removal

Transfer Case Assembly: Removal

WARNING: This page is about a different car, the 2003 Isuzu Rodeo Sport, 2003 Isuzu Rodeo, 2002 Isuzu Rodeo Sport, and 2002 Isuzu Rodeo. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Before removing transmission and transfer assembly from vehicle, change the transfer mode to 2WD using the 4WD rotary switch on dash panel.
  1. Disconnect battery ground cable.
  2. Raise and support vehicle with suitable stands. Drain transfer case fluid.
  3. Remove rear propeller shaft (1) and front propeller shaft (2).
    NOTE: Apply alignment marks on the flange at both front and rear sides.
  4. Disconnect harness connectors and clip.
    1. Connector: transfer switch, 2WD-4WD actuator, speed sensor.
      NOTE: Avoid turning the vehicle ignition switch to the ON position when the 2WD-4WD connector is removed (battery connected).
      If the ignition switch must be turned to the ON position, the controller must first be removed (memory must be cleared because the CHECK 4WD INDICATOR will light).
  5. Support transmission case with a transmission jack.
  6. Remove the top position bolt from transfer control lever hole and others under the floor.
    1. Remove transfer case (3) from the vehicle.
scientia non olet · About LEMON Manuals