LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 1998 >> Oasis LS >> Repair and Diagnosis >> Electrical >> Charging Systems >> Generator & Regulator - NIPPONDENSO >> On-Vehicle Testing >> Generator Control System Test >> Odyssey & Oasis

Odyssey & Oasis

  1. Turn ignition off. Disconnect 4-pin generator harness connector. Start engine and turn on headlights (high beam). Check voltage between generator harness connector terminal No. 2 (White/Green wire) and battery positive terminal. If voltage reading is one volt or less, go to next step. If voltage reading is not one volt or less, go to step  3 .
  2. Turn ignition and headlights off. Disconnect ECM 31-pin harness connector. Check continuity of White/Green wire between ECM harness connector terminal No. 2 and generator harness connector terminal No. 2. See WIRING DIAGRAMS  . If continuity exists, perform GENERATOR/REGULATOR TEST  . If continuity does not exist, repair open in White/Green wire between generator and ECM.
  3. Turn ignition and headlights off. Disconnect ECM 31-pin connector. Check continuity between ECM harness connector terminal No. 2 (White/Green wire) and body ground. If continuity does not exist, replace ECM with a known-good unit and repeat step 1). If continuity exists, repair short in White/Green wire between generator and ECM.
CAUTION: On Prelude, when substituting a known-good ECM, immobilizer code must be rewritten using Honda PGM tester, or engine will not start.
scientia non olet · About LEMON Manuals