Navigation System Function - Map - Matching
Map - matching repositions the vehicle on the road map when a new location is judged to be more accurate. This is done by comparing the current vehicle position (calculated by the normal position detection method) from the map data stored in the HDD (Hard Disk Drive).
There is a possibility that the vehicle position may not be corrected in the following case, and when vehicle is driven over a certain distance or time in which GPS information is hard to receive. Correct manually the current location mark on the screen.
- In map - matching, several alternative routes are prepared and prioritized in addition to the road judged as currently driving on.
Therefore, due to errors in the distance and/or direction, an incorrect road may be prioritized, and the current location mark may be repositioned to the incorrect road.
If two roads are running in parallel, they are of the same priority. Therefore, the current location mark may appear on either of them alternately, depending on maneuvering of the steering wheel and configuration of the road, etc.
- Map - matching does not function correctly when road on which the vehicle is driving is new, etc. and not recorded in the map data. Also, map - matching does not function correctly when road pattern stored in the map data and the actual road pattern are different due to repair, etc.
Therefore, the map - matching function judges other road as a currently driving road if the road is not in the map, and displays the current location mark on it. Later, the current location mark may be repositioned to the road if the correct road is detected.
- Effective range for comparing the vehicle position and travel direction calculated by the distance and direction with the road data is limited. Therefore, correction by map - matching is not possible when there is an excessive gap between current vehicle position and the position on the map.