Removal and Installation: Installation

Install bracket (1) to A/T fluid temperature sensor 2 (2).

Fig 1: Removing/Installing Bracket From A/T Fluid Temperature Sensor 2
Courtesy of NISSAN MOTOR CO., U.S.A.
Install A/T fluid temperature sensor 2 (1) with bracket (2) in control valve with TCM. Tighten A/T fluid temperature sensor 2 bolts to the specified torque.
(Bold Arrow) ← : Bolt

Fig 2: Identifying A/T Fluid Temperature Sensor 2 And Bracket
Courtesy of NISSAN MOTOR CO., U.S.A.
Connect A/T fluid temperature sensor 2 connector (A).
Engage A/T fluid temperature sensor 2 harness with terminal clip ((Bold Arrow) ←).

Fig 3: Identifying A/T Fluid Temperature Sensor 2 Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Install magnets (1) in oil pan.
Install oil pan gasket to oil pan.
CAUTION:
- Do not reuse oil pan gasket.
- Install it in the direction to align hole positions.
- Complete remove all moisture, oil and old gasket, etc. from oil pan gasket mounting surface.
  
  Fig 4: Identifying Magnets
  Courtesy of NISSAN MOTOR CO., U.S.A.
Install oil pan (2) (with oil pan gasket) and clips (1) to transmission case.
← : Vehicle front

(Bold Arrow) ← : Oil pan mounting bolt
CAUTION:
- Install it so that drain plug (3) comes to the position as shown in the figure.
- Be careful not to pinch harnesses.
- Completely remove all moisture, oil and old gasket, etc. from oil pan mounting surface.
  
  Fig 5: Locating Oil Pan Mounting Bolts
  Courtesy of NISSAN MOTOR CO., U.S.A.
Tighten oil pan mounting bolts to the specified torque in numerical order shown in the figure after temporarily tightening them. Tighten oil pan mounting bolts to the specified torque.
← : Vehicle front

CAUTION: Do not reuse oil pan mounting bolts.
Install drain plug to oil pan. Tighten drain plug to the specified torque.
CAUTION: Do not reuse drain plug gasket.

Fig 6: Identifying Tightening Sequence Of Oil Pan Mounting Bolts
Courtesy of NISSAN MOTOR CO., U.S.A.
Install bracket (2) to transmission assembly.
← : Vehicle front

(Bold Arrow) ← : Bolt
Install heated oxygen sensor 2 harness (B) to clips (1).
Connect heated oxygen sensor 2 harness connector (A).
Install exhaust mounting bracket. Refer to "EXPLODED VIEW ".
Pour ATF into A/T assembly. Refer to , "CHANGING ".
Connect the battery cable to the negative terminal.

Fig 7: Identifying Heated Oxygen Sensor 2 Harness Connectors And Heated Oxygen Sensor 2 Harness
Courtesy of NISSAN MOTOR CO., U.S.A.