LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2007 >> QX56 AWD >> Repair and Diagnosis >> Steering >> Power Steering System >> Steering Column >> Removal and Installation >> Removal

Removal and Installation: Removal

  1. Remove combination switch and spiral cable from steering column assembly. Refer to "REMOVAL AND INSTALLATION ".
  2. Remove the tilt motor and tilt sensor. Refer to "REMOVAL AND INSTALLATION ".
  3. Remove steering column cover, ADP steering switch and ignition key finisher. Refer to "REMOVAL AND INSTALLATION ".
  4. Remove lock nut and bolt, then separate upper shaft from upper joint.
    Fig 1: Locating Lock Nut And Bolt
    G04902301
  5. Remove two nuts and two bolts, then remove steering column assembly from steering member.
    Fig 2: Locating Hole Cover Nuts
    G04902302
  6. Remove hole cover seal and clamp.
  7. Remove mounting nuts, then remove hole cover from dash panel.
  8. Raise vehicle, then remove mounting bolt (lower side) of lower joint shaft and remove lower joint shaft and upper shaft as an assembly.
    Fig 3: Locating Bolt (Lower Side) Of Lower Joint
    G04902303
scientia non olet · About LEMON Manuals