Removal And Installation

Refer to COMPONENTS (WITHOUT AUTOMATIC DRIVE POSITIONER) and COMPONENTS --> for tightening torque. Install in the reverse order of removal.
NOTE: Refer to component parts location and do not reuse non-reusable parts.
Confirm with mating marking that if it is in phase with hose and clamp, then correct if needs.

Fig 1: Identifying Mating Marking
Courtesy of NISSAN MOTOR CO., U.S.A.
To install eye joint, join projection of eye joint into notch of power steering pump, and attach eye joint to power steering pump properly. Then, tighten eye bolt by hands fully, and tighten it with a specified torque.
Connect harness connector into pressure sensor securely.

Fig 2: Joining Projection Into Notch Of Power Steering Pump
Courtesy of NISSAN MOTOR CO., U.S.A.

Refer to COMPONENTS (WITHOUT AUTOMATIC DRIVE POSITIONER) and COMPONENTS for tightening torque. Install in the reverse order of removal.
NOTE: Refer to component parts location and do not reuse non-reusable parts.
Confirm with mating marking that if it is in phase with hose and clamp, then correct if needs.

Fig 1: Identifying Mating Marking
Courtesy of NISSAN MOTOR CO., U.S.A.
To install eye joint, join projection of eye joint into notch of power steering pump, and attach eye joint to power steering pump properly. Then, tighten eye bolt by hands fully, and tighten it with a specified torque.

Fig 2: Joining Projection Of Eye Joint Into Notch Of Power Steering Pump
Courtesy of NISSAN MOTOR CO., U.S.A.