| C1290 |
Torque sensor signal error |
First erase DTC, check connector connection. |
In case of reoccurrence, replace column & housing. |
| C1112 |
Torque sensor voltage error |
Check connector between torque sensor and ECU. |
In case of reoccurrence, replace ECU. |
| C1705 |
ECU hardware error |
First erase DTC and then check, check ECU connector. |
| C1604 |
ECU over/discharge error |
| C2413 |
ECU hardware error |
| C2400 |
Motor signal error |
II n case of reoccurrence, replace motor. |
| C2401 |
Motor circuit error |
| C2412 |
Motor voltage supply error |
First erase DTC and check, Check ECU/motor connector. |
First replace ECU. In case of reoccurrence, replace motor. |
| C1259 |
Angle sensor signal error |
After Resetting zero point & erasing DTC, check connector connection condition. |
In case of reoccurrence, replace column & Housing. |
| C1261 |
Zero-setting error |
After Resetting zero point, recheck. |
Reset the zero-setting. |
| C1102 |
Battery voltage problem |
Check battery voltage condition. |
Recharge battery voltage. |
| C1696, C1697 |
SPAS signal error |
Check SPAS. |
Erase DTC (MDPS is not to be replaced). |
| C1612, C1646 |
TCU signal error |
Check TCU. |
| C1628, C1656 |
Instrument cluster signal error |
Check instrument cluster. |
| C1692, C1693 |
VSM signal error |
Check VSM. |
| C1260 |
Angle sensor signal error |
After resetting the angle, recheck. If C1259 does not occur, check CAN line. |
Reset Angle sensor. Erase DTC. |
| C1611 |
CAN time out EMS |
- Check G-SCAN condition.
- Check connector connection.
- Check ECU CAN line.
- Check MDPS ground line.
|
Check the EMS CAN Line. |
| C1616 |
CAN BUS OFF |
Check the chassis CAN Line. |
| C1622 |
Vehicle speed signal error |
Check the EMS (Engine ECU). |
| C1623, C1687, C1688 |
Can time out Steering angle sensor |
- Check MDPS Power Connector & FUSE
- Check MDPS Ground line
- Check MDPS ECU/VSM CAN line
- Communication status with GDS
|
In case of reoccurrence, replace ECU (Heavy steering and no communication) |