LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Elantra GT Automatic Trans >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag Modules And Clock Spring >> Driver Airbag (DAB) Module And Clock Spring >> Repair Procedures >> Removal

Repair Procedures: Removal

  1. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
  2. Remove the driver airbag module from the steering wheel after pressing the snap fit pin stopper.
    Fig 1: Locating Snap Fit Pin Stopper
    G12074605Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the wiring fixing clip (C) and disconnect the horn connector (A).
    Fig 2: Locating Wiring Fixing Clip, Horn Connector And Driver Airbag Module Connector
    G12074606Courtesy of HYUNDAI MOTOR AMERICA
  4. Release the connector locking pin, then disconnect the driver airbag module connector (B).
    CAUTION: The removed airbag module should be stored in a clean, dry place with the pad cover facing up.
  5. Remove the steering wheel

    (Refer to "STEERING WHEEL ")

  6. Remove the steering column shroud.
    Fig 3: Steering Column Shroud With Screws
    G12074607Courtesy of HYUNDAI MOTOR AMERICA
  7. Disconnect the clock spring and horn connector, then remove the clock spring.
Fig 4: Locating Clock Spring And Horn Connector
G12074608Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals