Repair Procedures: Installation

Fix the brake pedal arm and insert fully the stop lamp switch as hiding contact part.

Fig 1: Inserting Brake Pedal Arm
Courtesy of HYUNDAI MOTOR AMERICA
After inserting, turn the stop switch (A) 45° clockwise, and then assemble locking plate (B) by pushing.

Fig 2: Turning Stop Switch 45° Clockwise
Courtesy of HYUNDAI MOTOR AMERICA
Confirm the gap between stop lamp switch and bracket.
Stop lamp clearance: 1.0 ~ 2.0 mm (0.04 ~ 0.08 in.)

Fig 3: Checking Gap Between Stop Lamp Switch And Bracket
Courtesy of HYUNDAI MOTOR AMERICA
Connect the stop lamp switch connector.
NOTE: If the gap between stop lamp switch and bracket is not 1.0 ~ 2.0 mm (0.04 ~ 0.08 in), perform the above process again.
Install the lower crash pad.
(Refer to Body - "CRASH PAD ")