LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2006 >> Elantra Limited >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System (F4A42) >> Automatic Transaxle System >> DTC P0707 Transaxle Range Switch - Low Input >> Monitor SCANTOOL Data

Monitor SCANTOOL Data

  1. Connect scantool to data link connector (DLC).
  2. Ignition "ON" & Engine "OFF".
  3. Monitor the "TRANSAXLE RANGE SWITCH" parameter on the scantool.
  4. Move selector lever from "P" range to "L" range.
    Fig 1: Scan Tool Display - Current Data
    G04924186Courtesy of HYUNDAI MOTOR CO.
  5. Does "TRANSAXLE RANGE SWITCH" follow the reference data?

    Yes: 

    • Fault is intermittent caused by poor contact in the sensor's and/or TCM (PCM)'s connector or was repaired and TCM (PCM) memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    No: 

scientia non olet · About LEMON Manuals