LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2006 >> Accent Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transaxle System (A4AF3)) >> Automatic Transaxle System >> DTC P1709 Kick Down Switch >> Monitor SCANTOOL Data

Monitor SCANTOOL Data

WARNING: This page is about a different variant/trim than selected.
  1. Connect scantool to data link connector(DLC).
  2. Engine "ON".
  3. Monitor the "K/D SWITCH" parameter on the scantool.
  4. Operate the vehicle from "1st" gear to "4th" gear.
    Fig 1: Scan Tool Display - K/D Switch
    G04802141Courtesy of HYUNDAI MOTOR CO.
  5. Does "K/D SWITCH" follow the reference data?

    YES  : --> Fault is intermittent caused by poor contact in the sensor's and/or PCM's connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO  : --> Go to "TERMINAL & CONNECTOR INSPECTION " procedure.

scientia non olet · About LEMON Manuals