Installation Procedure

Fig 1: Exploded View Of Clutch Release Switch

Courtesy of GENERAL MOTORS CORP.

Slide the clutch pedal position switch (3) with retaining plate (2) into the clutch pedal bracket (1), until the locking tabs (2) are fully engaged.

Fig 2: Clutch Release Switch Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector (2) to the clutch pedal position switch (1).
Complete the following in order to adjust the clutch pedal position switch (1).
1. Push the switch fully into the bracket, allowing the switch to ratchet in the retaining plate.
2. Depress the clutch pedal all the way to the floor.

WARNING: Replacement or reprogramming of the ECM, or replacement of the clutch pedal position sensor (CPPS) or clutch pedal requires that a CPPS learn procedure be performed. Failure to perform the CPPS learn procedure may result in personal injury or damage to the vehicle or its components if the vehicle is in gear and the starter motor is accidentally engaged.

Perform the clutch pedal position sensor learn procedure. Refer to Clutch Pedal Position Sensor Learn .