DTC U3000-51: Reprogramming error(Gauge Control Module)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2020 Honda Fit, 2019 Honda Fit, 2018 Honda Fit, 2017 Honda Fit, and 2016 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
| DTC Description | DTC |
|---|---|
| U3000-51 Reprogramming error |
DTC (Gauge Control Module)
NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A - Refer to: Body Electrical Troubleshooting - B-CAN System Diagnosis Test Mode A - Initial Communication and DTC Checks .
NOTE:
- Before update the gauge control module, make sure the 12 volt battery in the vehicle is fully charged, and connect a 12 volt jumper battery (not a battery charger) to maintain system voltage.
- Never turn the vehicle to the ACCESSORY mode or OFF (LOCK) mode, during the reprogramming. If there is a problem with the reprogramming, turn the vehicle to the ON mode.
- Problem verification:
- 1. Turn the vehicle to the ON mode.
- 2. Clear the DTCs with the HDS.
- 3. Turn the vehicle to the OFF (LOCK) mode and then the ON mode.
- 4. Wait for at least 6 seconds.
- 5. Check for DTCs with the HDS.
DTC Description DTC U3000-51 Reprogramming error Is DTC U3000-51 indicated?
YES
Reprogramming the gauge control module.
NO
Intermittent failure, the system is OK at this time.