Ignition Switch Test (Without Keyless Access System): Test

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2020 Honda Fit, 2019 Honda Fit, 2018 Honda Fit, 2017 Honda Fit, and 2016 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.

SRS components are located in this area. Review the SRS component locations and the SRS precautions and procedures before doing repairs or service.

12 Volt Battery Terminal - Disconnect
Column Cover - Remove

Ignition Switch - Test

Courtesy of HONDA, U.S.A., INC.

1. Disconnect the connector (A).

2. Check for continuity between the terminals in each switch position according to the table.

3. If the continuity is not as specified, replace the ignition switch (B).

Courtesy of HONDA, U.S.A., INC.

All Removed Parts - Install

1. Install the parts in the reverse order of removal.