LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2011 >> CR-Z Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Seat Heaters) >> Switch Test/Replacement

Switch Test/Replacement

WARNING: This page is about a different car, the 2016 Honda CR-Z, 2015 Honda CR-Z, 2014 Honda CR-Z, 2013 Honda CR-Z, and 2012 Honda CR-Z. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the center console panel (see CENTER CONSOLE REMOVAL/INSTALLATION ).
  2. Disconnect the 6P (or 7P*) connector from the seat heater switch, then remove the switch.

    *: Passenger's seat heater switch

    Fig 1: Identifying Passenger's Seat Heater Switch 6P (7P) Connector Terminals
    G00514337Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Check for continuity between the terminals in each switch position according to the table.
    NOTE:
    • Make sure the correct test lead (+ or -) is placed on the terminal.
    • When checking for continuity across the diode, use the diode setting ($$) on the digital volt/ohm meter to check the diode bias.
    • Be aware of this characteristic; a diode is one that conducts fully in one direction (forward) and not at all in the opposite direction (reverse).
    Fig 2: Terminal Continuity Chart
    G00514338Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. If the continuity is not as specified, replace the switch.
  5. Install the switch in reverse order of removal.
scientia non olet · About LEMON Manuals