LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2011 >> CR-Z Base, Standard >> Repair and Diagnosis >> Body & Frame >> Seats >> Active Head Restraint Inspection

Active Head Restraint Inspection

NOTE: If the vehicle has been in a collision, always inspect the active head restraint, even if they appear reusable, by doing the following procedure.
  1. Fold the seat-back forward, then recline the seat-back to the first lock position.
  2. Apply masking tape (A) on the top of the head restraint (B).
    Fig 1: Applying Masking Tape On Top Of Head Restraint
    G06953452Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Make a mark (C) at the center point of the head restraint. Use the mark for the measurements in step  4.
  4. Push the head restraint (A) forward, and measure the horizontal head restraint movement. The head restraint should move more than 52 mm (2.05 in) without resistance. If it is less than 52 mm (2.05 in), or the head restraint does not move smoothly, replace the seat frame assembly (see SEAT FRAME REPLACEMENT  ).
    Fig 2: Measuring Horizontal Head Restraint Movement
    G06953453Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals