LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 1996 >> Prelude VTEC >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Bleeding Brake System >> Accumulator, Modulator & Abs Pump (Power Unit) Bleeding

Accumulator, Modulator & Abs Pump (Power Unit) Bleeding

  1. Ensure vehicle is on level ground. Ensure transmission is in Park (A/T) or Neutral (M/T). Block wheels, and release parking brake. Turn ignition off. Connect ABS Tester (07HAJ-SG0010B) to Orange 6-pin test connector, located under passenger's seat.
  2. Fill modulator reservoir to MAX level. Start engine and allow to idle for a few minutes. Shut down engine and recheck fluid level. Relieve accumulator line pressure. See RELIEVING ACCUMULATOR/LINE PRESSURE  .
    NOTE: Depress brake pedal firmly when operating ABS tester.
  3. Start engine and allow to idle for a few minutes. Turn mode selector to "2" position. While depressing brake pedal firmly, press START TEST button to operate modulator/pump. See Figure . There should be kickback on brake pedal. If there is no kickback or kickback is weak, repeat steps 2) and 3).
  4. Turn mode selector to "3", "4" and "5". Perform steps 2) and 3) in each mode. Refill reservoir to MAX level.
WARNING: DO NOT drive vehicle with ABS tester connected to vehicle. A collision can result from a reduction, or complete loss of brake operation.
scientia non olet · About LEMON Manuals