Clutch Assembly: Installation
- Position clutch disc and pressure plate on flywheel using Clutch Centering Tool (J-34860). Clutch disc is installed with damper springs facing toward transaxle.
- Tighten pressure plate bolts alternately and evenly in a diagonal pattern to specification. Lightly lubricate release bearing sliding surfaces and input shaft with grease.
- To complete installation, reverse removal procedure. Tighten all retaining nuts and bolts to specification. Refer to the TORQUE SPECIFICATIONS table. Fill transaxle with 75W GL-5 Fluid (12345349).
CLUTCH SPECIFICATIONS
| Application | In. (mm) | |
|---|---|---|
| Disc Runout (Maximum) | 0.031 (0.79) | |
| Flywheel Runout | 0.004 (0.10) | |
| Minimum Rivet Depth | 0.5 (0.20) | |
| Standard (New) Rivet Depth | ||
| 1.0L Engine | 0.05 (1.30) | |
| 1.3L Engine | 0.06 (1.50) | |