(Stiffener Assembly Removal And Installation)
Abbreviated Procedures
| Work | H/W | Tightening torque N.m (kgf.m/lb-ft) | SST/Equipment | Chemical | etc | |
|---|---|---|---|---|---|---|
|
||||||
| 1 | Disconnect the battery negative (-) terminal | - | - | Diagnostic tool | - | - |
| 2 | Remove the side garnish | Fastener | - | - | - | - |
| 3 | Remove the fender garnish | Fastener | - | - | - | - |
| 4 | Remove the front trunk mat | - | - | - | - | - |
| 5 | Remove the front trunk plug hole | - | - | - | - | - |
| 6 | Remove the front trunk | Bolt | 7.8 - 11.8 (0.8 - 1.2/5.8 - 8.7) | - | - | - |
| 7 | Disconnect the front trunk lamp connector | - | - | - | - | - |
| 8 | Open the charge door | - | - | - | - | - |
| 9 | Remove the charge door inlet cap | - | - | - | - | - |
| 10 | Remove the PE room side cover [LH/RH] | Clip | - | - | - | - |
| 11 | Remove the front bumper upper cover | Clip | - | - | - | - |
| 12 | Remove the front bumper assembly | Clip/Screw | - | - | - | - |
| 13 | Disconnect the front bumper connector | - | - | - | - | - |
| 14 | Remove the VESS Unit & Speaker assembly | Bolt | - | - | - | - |
| 15 | Disconnect the VESS unit & speaker assembly connector | - | - | - | - | - |
| 16 | Disconnect the front radar connector | - | - | - | - | - |
| 17 | Remove the front radar | Bolt | 8.8 - 10.8 (0.9 - 1.1/6.5 - 8.0) | - | - | - |
| 18 | Remove the mounting bolt and separate the charging port | Bolt | - | - | - | - |
| 19 | Remove the front bumper beam assembly | Nut | 3.9 - 5.9 (0.4 - 0.6/2.9 - 4.3) | - | - | - |
| Bolt | 30.4 - 46.1 (3.1 - 4.7/22.4 - 34.0) | |||||
| 20 | Remove the stiffener assembly | Bolt | 0.8 ~ 1.2 | - | - | - |
|
||||||
| Install in the reverse order of removal | ||||||
|
||||||
|
||||||