Installation Procedure
Windshield Wiper System Module Shield (1) - Install
Air Inlet Grille Panel (2) - Install
- Windshield Washer Nozzle Hose - Install [ 3x ]
- Air Inlet Grille Panel Retainer (1) - Install [ 8x ]
Hood Rear Outer Air Inlet Seal (2) - Install [ 2x ]
- Hood Rear Outer Air Inlet Seal Retainer (1) - Install [ 2x ]
Air Inlet Grille Panel Extension (1) - Install [ 2x ]
- Remove the double layer of masking tape around the perimeter of the painted surfaces.
- Using a 50/50 mixture of isopropyl alcohol and clean drinkable water with a clean towel, remove any left over adhesive residue from the masking tape.
Clean the left and right side windshield wiper transmission pivot shaft splines with a soft wire brush before installing the windshield wiper arms (3).
- Position the windshield wiper arms (3) on the windshield wiper transmission pivot shaft.
- Windshield Wiper Arm Nut (2) - Install and tighten [ 2x ] - Fastener Specifications
- Windshield Wiper Arm Finish Cap (1) - Install [ 2x ]
If required, realign the windshield wipers to their respective alignment circles (1) on the windshield.
- Lubricate the windshield with clean washer fluid.
- Run the windshield wipers for two complete cycles then turn off the windshield wipers.
- Ensure the windshield wipers are in the full park position.
CAUTION:
Refer to Fastener Caution .