Lead Terminal Repair
Materials
| Name | Specification |
|---|---|
| Motorcraft® Ultra-Clear Spray Glass Cleaner (U.S.) ZC-23 (U.S.) | ESR-M14P5-A |
Repair
- 1.WARNING: Before beginning any service procedure in this service information, refer to Safety Warnings in GENERAL INFORMATION . Failure to follow this instruction may result in serious personal injury.
Refer to: Health and Safety Precautions .
- 2.
Bring the vehicle up to a room temperature of at least 16°C (60.8°F) or above.Temperature
: 60.8°F (16°C)
- 3.
- Terminal Kit - Back Glass 4F1Z-14421-AA
Clean the bus bar in the area to be repaired with steel wool (000 to 0000 grade), and then with glass cleaner to remove all dirt, wax, grease, oil or other foreign material.
Material
: Motorcraft® Ultra-Clear Spray Glass Cleaner (U.S.) / ZC-23 (U.S.) (ESR-M14P5-A)
NOTE:
The new terminal covers the original terminal location, but it must be placed so the terminal conductive areas will be placed on a good conductive base.
- 4.
Place the replacement terminal type A over the original tab location, making sure the conductive areas of the terminal are on a good conductive area. Do not place the terminal tab foot on the original location, which does not have conductive material.
NOTE:
Depending on the original terminal location, and whether the terminal is covered by pillar trim, determines where to locate the new terminal. Some grid line bus bars may only allow the placement of the terminal above or below the original tab location due to space limitations. For most vehicle applications, the replacement tab location covers the original tab location, but still allows the replacement tab to attach to the bus bar on good conductive material.
NOTE:
Do not use any type of flame torch or flame-heated soldering gun for this procedure. Use of these tools provide inadequate heat generation at the tip and the exhaust heat can cause damage to plastic trim parts in the area. Use only an electric soldering gun with 100 watts or more of power. Before using the soldering gun, be sure to melt a small amount of rosin core solder to the tip. The solder helps achieve better heat transfer from the soldering gun tip to the new terminal.
- 5.
Hold the terminal in place with an item such as a regular lead pencil at a 90 degree angle from the terminal (Holding at other than a 90 degree angle may allow the terminal to slip when the solder liquefies).
- 6.
Place the soldering gun tip on the top of the terminal, but not on the painted areas of the tab. Energize the soldering gun and watch for the painted area of the terminal to liquefy and change color. The paint should liquefy in approximately 25-45 seconds after heating. As soon as the paint color completely changes on either side of the terminal, de-energize the soldering gun and continue to hold the terminal in place with the soldering gun and pencil for an additional 30 seconds.
NOTE:
The new terminal has pre-applied solder, flux and temperature-sensitive paint. The temperature-sensitive paint liquefies and changes color when the terminal has reached the correct temperature to melt solder on the terminal.