Disassembly And Assembly Of Subassemblies: Differential: Disassembly
WARNING:
Before beginning any service procedure in this article, refer to Safety Warnings in GENERAL INFORMATION
. Failure to follow this instruction may result in serious personal injury.
- Refer to: HEALTH AND SAFETY PRECAUTIONS .
-
NOTE: Install new bearings if necessary.
-
NOTE: Remove the bearing using a Bearing Puller and Step Plate.
Use Special Service Tool: 204-069 (T81P-1104-C) Remover/Installer, Front Wheel Hub .
Use the General Equipment: Puller
-
NOTE: Remove the bearing using a Bearing Puller and Step Plate.
Use Special Service Tool: 204-069 (T81P-1104-C) Remover/Installer, Front Wheel Hub .
Use the General Equipment: Puller
-
NOTE: If the ring gear is replaced, a new transfer shaft must also be installed.