Programming the Auto-Unlock Feature Using the Door Lock Control Switch
NOTE:
The auto-unlock feature can be activated or deactivated independently of the autolock feature.
NOTE:
The auto-unlock feature of the SJB
can also be configured on or off with the scan tool. For additional information on module configuration, refer to MODULE CONFIGURATION
.
- Close all the doors.
- Confirm that the ignition switch is in the OFF position.
- Turn the ignition switch from OFF to ON.
- Press the door lock control switch unlock button 3 times.
- Turn the ignition switch from ON to OFF.
- Press the door lock control switch unlock button 3 times.
- Turn the ignition switch from OFF to ON. The horn chirps once to indicate that programming mode is entered.
- To enable/disable the auto-unlock feature, press the lock button on the door lock control switch then the unlock button. The horn chirps once if auto-unlock is disabled or twice (one short chirp followed by a honk) if auto-unlock is enabled.
- Turn the ignition key to the OFF position. The horn chirps once to signal that the programming is complete.
NOTE:
Steps 4 through 8 must be carried out within 30 seconds.